TILT – axis moving range
Basically:
The TILT-axle is the axle which moves the lamp
vertically
.
Normally the factory presettings are
suitable
and nothing must be set. The lamp can be
moved from vertically down to a few degrees on the top.
The 0-degree position represents the
horizontal even
position of the lamp. From this
position a
positive
moving range and a
negative
moving range is defined. The positive
range is much smaller than the negative range. This is the reason why it can not be
determined where the 50% DMX position is.
TILT moving range is in opposite to the PAN moving range asymmetric. It is set in two
menus. (P12, page 32 and P13 page 33).
If a correction must be made do proceed with the following steps:
Use menu
P06, TILT-axle 0-position, page 30
, to move the yoke onto 0-position. When the
value is changed one time (up or down), the yoke starts moving on this position.
Wait until the motoryoke
does not move
anymore.
Now it is possible to set a new 0-position
roughly
by exerting the tripping lever. To
fine
adjust use
P06, TILT-axle 0-position, page 30.
22
Motoryoke MB D1 V4.56 Rev 1.06
+20°
0°- position
-90°
TILT- positive
moving range
TILT-negative
moving range
Entire moving range
