Quick start guide
Prior starting, observe the safety and operating instructions on page 4!!!
Follow the description
step by step
to mount the lamp and program the yoke!
For
cable connections
, please refer to section
cabling, page 16
.
Assembling position:
First, the yoke must move to build-in position. The yoke can stand on the floor or hang in a
rigg. Connect power cable, but let it switched off. Push the UP button and switch on. This
is the indicator for the electronic, that a lamp will be mounted.
If you are using the focus drive, connect it but do
not
mount it to the focus knob of the
lamp. No DMX-signal is needed. At the moment
NO
lamp is necessary!
Press the
UP
button and
power up
the yoke.
Wait until “adjust” is indicated. Release the button.
The electronic moves the axes including focus (if used
and connected) to the build-in position.
Wait
until “ready” is shown.
The yoke is ready to mount the lamp.
Power off
the yoke or switch it off
Mounting direction:
Front
is the side with the Licht-Technik logo.
Back
is the
side with the connectors.
Mount the lamp so that the light is in the front.
8
Motoryoke MB D1 V4.56 Rev 1.06
