Getting started
Assemble the lamp like illustrated in
quick setup guide
on page 8.
Setup the motoryoke on the desired place
according
to the
operating and safety
instructions, page 4.
Mount
Focus unit
if used. Refer to
Quick start guide, page 8.
Set the
middle position
mechanically and roughly of pan axis like illustrated on page 21.
Cable
the motoryoke like illustrated in
cabling, page 16.
Switch on
the motoryoke. After testing its internal program memory and the control it
shows the overall operating hours. Now the motoryoke is moving to the programmed
position. The second display line shows the DMX-address and value of the PAN-axle.
Caution!
Make sure that the motoryoke is not moved by the
control panel
before programming.
Otherwise the motoryoke will move during programming if the position is changed at the
panel!
If the focus unit is used program
P02 Focus unit on/off
, page 27 to 1. If not program it to 0.
Program the
middle position
exactly at the display via P05, refer to
programming the
middle position
on page 29.
Program the
moving range
of the
PAN
-axle. Refer to
P11, PAN-axle moving range, page
31.
Normally not necessary, but possible is the programming of the
TILT moving range
. Refer
to
TILT-axle moving range,
page
22.
If you are using a control desk with
joystick
,
vision control
or
LT-Pilot
the speed channel
setup in P27, page 36, must be programmed to 1!
If you are using a standard DMX desk P27
can
be programmed to 1 or 0. Decide for
yourself how you want to control the speed.
Further
programming possibilities
like DMX addressing are specified on the following
pages.
Tip:
When the motoryoke is in
programming mode
, all moving orders are ignored. Make sure
that the device is in operating mode after programming, otherwise it will not move! Press
two times the OK key for leaving the programming mode!
Motoryoke MB D1 V4.56 Rev 1.06 19
