A safety device that was
once loaded
or is visibly damaged
must not
be used anymore!
When working on the motoryoke, it must be
switched off
or the power line must be
interrupted. Make sure that the Motoryoke cannot be moved by the control panel.
The operator must make sure that
no person
is in the swivelling range of the motoryoke.
Inform your coworker and colleagues that the motoryoke is behaving like a work robot.
When the position is changed at the control panel the device is trying to move on this
position. There is the danger of being bruised and get frightened.
Admissible ambient
temperature
: 0..45 degree Celsius.
The motoryoke must not be
lit
directly
by the lamp. Limit the range of rotation (TILT axle)
so that the headlight
does not shine
on the motoryoke.
Check the whole swivelling range of the headlight. The manufacturers of the lamps specify
minimum permissible distances
to inflammable materials. Make sure that these
distances are attended in every position of the lamp.
The manufacturers of the lamps specify maximum
inclination
. HMI headlights are not
allowed to operate with the ignition electronic on the top.
The motoryoke must be kept
dry
. In case of water condensation a waiting period of up to
2 hours is necessary until acclimatisation is reached.
If
knobs
for manual moving are mounted, they can only be used if the motoryoke is in
power off condition. If the device is switched on and the knobs are rotated manually the
motors and/or gearboxes can be damaged.
Make sure to mount the lamp in the weight balancing point. The motoryoke must only be
operated with balanced tilt, otherwise the motor and/or gearbox can be damaged.
Observe the right cabling. The cable-loop must be wide enough and the correct cable-
route must be observed. The cables with the safety belt are last fixed left beside the safety
hole of the motoryoke. The cable package is routed over the mounting bridge and under
the pipe of the rigg:
Wrong routed cables can lead to defective cables, because of the mechanic and thermic
influence!
Check the complete pan moving range before starting the equipment by turning by hand!
Too short cable loops can block the pan axis!
6
Motoryoke MB D1 V4.56 Rev 1.06
