Important Information for the LG LS992
138
Because the phone is designed to operate at multiple power levels to use only the power required to
reach the network, in general, the closer you are to a wireless base station antenna, the lower the power
output. Before a phone model is available for sale to the public, it must be tested and certified to the FCC
that it does not exceed the limit established by the government adopted requirement for safe exposure.
The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by
the FCC for each model.
While there may be differences between SAR levels of various phones and at various positions, they all
meet the government requirement for safe exposure. The FCC has granted an Equipment Authorization
for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF emission
guidelines. SAR information on this model phone is on file with the FCC and can be found under the
Display Grant section of
http://www.fcc.gov/oet/ea/fccid/
after searching for FCC ID
ZNFLS992
.
To find information that pertains to a particular model phone, this site uses the phone FCC ID number
which is usually printed somewhere on the case of the phone. Sometimes it may be necessary to remove
the battery pack to find the number. Once you have the FCC ID number for a particular phone, follow the
instructions on the website and it should provide values for typical or maximum SAR for a particular
phone. Additional information on Specific Absorption Rates (SAR) can be found on the Cellular
Telecommunications Industry Association (CTIA) website at
http://www.ctia.org/
.
*In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg
(W/kg) averaged over one gram of tissue. The standard incorporates a substantial margin of safety to
give additional protection for the public and to account for any variations in measurements.
FCC Notice
Part 15.19 statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Part 15.21 statement
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
