51
206-4261
FTG Mode of Operation (Cont.)
Optional Manual Configuration / TV Setup
The manual configuration procedures below should only be performed if you want to save
customized TV setup menu settings to the FTG Configuration file and/or if you do not know the
RF channels at the site and need to “Learn” FTG Configuration from an LY560M TV as described
above. Ensure the TV is in Pass-through Mode before you begin.
These configuration procedures parallel the initial steps required for creating a custom Master TV
Setup. See also screen examples on pages 32 to 33.
Set Installer Menu Items
These steps provide specific instruction only on the Installer Menu items that should be set on an
LY560M TV. Refer to pages 21 to 30 for detailed information on all Installer Menu items.
1. If not done already, turn ON the TV.
If the Express Script Installer Menu Wizard appears on the screen when you turn ON the TV, exit
the wizard.
2. Use the Installer Remote to access the PTC Installer Menu (see “Accessing the Installer Menu”
on page 21 for further information).
The next step depends on whether the Express Script Installer Menu Wizard appeared when you
turned ON the TV:
• If the wizard did appear, the TV is in a factory default state, and you can proceed to set
Installer Menu items. Go to step 4.
• If the wizard did not appear, go to step 3.
(Continued from previous page)
6. In the Learn From TV (TLX) window, to differentiate this TLX file from others, you can use the
Up/Down arrow keys to change the last five digits of the filename. Press
OK
when you are ready
to initiate Learning.
Learning status will be shown on a progress bar in a new window. Do NOT remove the USB
device until Learning is complete. When the Learning process is complete, the TV Manager /
USB Download Menu will reappear on the screen.
7. When Learning is done, press
CC
or on the Installer Remote to exit the TV Manager / USB
Download Menu, and remove the USB memory device.
Note: During Learning, logical channel numbers are automatically assigned in
ascending order, starting with 0 (zero), to the physical RF channels of the TV channel
lineup. See also note below.
Note: It is highly recommended that you open this FTG Configuration file in the FTG
File Manager—BEFORE transferring (Teaching) the file to any Target TVs—to verify
FTG Channel Map and FTG Installer Menu settings and enable decryption by marking
Pro:Idiom encrypted channels. This will also enable you to confirm channels and add
channel attributes, labels, etc.
(Continued on next page)
