LevelOne GEL-2670, User Manual, Page: 128 / 320

C
HAPTER
4
| Configuring the Switch
Creating Trunk Groups
– 128 –
Figure 42: Static Trunk Configuration
C
ONFIGURING
LACP
Use the LACP Port Configuration page to enable LACP on selected ports,
configure the administrative key, and the protocol initiation mode.
P
ATH
Basic/Advanced Configuration, Aggregation, LACP
U
SAGE
G
UIDELINES
◆
To avoid creating a loop in the network, be sure you enable LACP before
connecting the ports, and also disconnect the ports before disabling
LACP.
◆
If the target switch has also enabled LACP on the connected ports, the
trunk will be activated automatically.
◆
A trunk formed with another switch using LACP will automatically be
assigned the next available trunk ID.
◆
If more than eight ports attached to the same target switch have LACP
enabled, the additional ports will be placed in standby mode, and will
only be enabled if one of the active links fails.
◆
All ports on both ends of an LACP trunk must be configured for full
duplex, either by forced mode or auto-negotiation.