Leuze electronic webConfig tool – Extended configuration
Leuze electronic
BPS 348i
74
Table 9.1:
webConfig system requirements
9.1.2 Installing the USB driver
Start your PC with administrator privileges and log on.
Download the setup program from the Internet:
Leuze website
> Products > Measuring Sensors > Sensors for Positioning > BPS 300i > (Name of the
BPS) > Tab Downloads > Software/driver.
Start the setup program and follow the instructions.
9.2
Starting the webConfig tool
Prerequisite: The Leuze electronic USB driver for the webConfig tool is installed on the PC.
Connect the operating voltage to the BPS.
Connect the SERVICE USB interface of the BPS to the PC.
The connection to the SERVICE USB interface of the BPS is established via the PC-side USB interface.
Use a standard USB cable with one Type A plug and one Mini-B-type plug.
Start the webConfig tool using your PC's Internet browser with IP address 192.168.61.100
This is the default Leuze electronic service address for communication with bar code positioning sys
-
tems of the BPS 300i series.
The webConfig start page appears on your PC.
Operating system
Windows XP (Home Edition, Professional)
Windows Vista
Windows 7
Windows 8
Computer
PC with USB interface version 1.1 or higher
Graphics card
min. 1024 x 768 pixels or higher resolution
Required disk space
for USB driver
10 MB
Internet browser
Internet Explorer version 8.0 or higher
Firefox version 4.0 or higher
Alternatively, you can manually install the LEO_RNDIS.inf USB driver.
Contact your network administrator if the installation fails.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: [email protected]
