Safety instructions
General safety and application notes for Lenze control systems
l
9
LDEDS−CCU210B EN 4.0
Application as directed
The Lenze control system is designed for operation on a travelling drive (short−time brake
applications permissible only). Without protection of persons (optional) the control
system is not suitable for hoist applications!
Lenze control systems are components intended for installation in electrical systems or
machines. They are not household appliances, but are designed as components exclusively
for application for commercial or professional use according to EN 61000−3−2. The
documentation contains notes for maintaining the limit values to EN 61000−3−2.
If the control systems are installed in machines, commissioning (i.e. starting operation as
directed) is prohibited until it has been determined that the machine corresponds to the
regulations of EC Directive 98/37/EC (Machinery Directive); observe EN 60204.
The commissioning (i.e. starting the intended operation) is only allowed if the EMC
Directive (89/336/EEC) is met.
The Lenze control systems meet the requirements of Low−Voltage Directive 2006/95/EC.
The harmonised standards of the EN 61800−5−1, EN 61800−3, EN 61800−2 series are
applied to the Lenze control systems.
Technical data and connection requirement information appear on the nameplate and in
the documentation. They must be observed.
Warning:
The control systems are products for the use in a second environment in
accordance with EN 61800−3 (industrial environment). These products can cause radio
interferences in residential areas. In this case it may be required for the operator to
implement corresponding measures.
Transport, storage
Observe the notes for transport, storage and proper handling.
Observe the climatic conditions according to EN 61800−2.
Installation
The control systems must be set up and cooled according to the regulations of the
accompanying documentation.
Ensure careful handling and avoid mechanical overload. Do not bend any components
during transport or handling or change insulation distances. Do not touch any electronic
components or contacts.
Lenze control systems contain electrostatic sensitive components that can easily be
damaged by improper handling. To avoid risks to health, do not damage or destroy any
electrical components!