Information LH100 V3.6
55
When you are ready to program press
the 'Enter' key.
A "P" will be displayed briefly on the
bottom of the display to indicate that
the programming has taken place.
x4
Press the 'ESC' key four times to
completely exit PoM and return to
operating trains.
With PoM you can only write values into a CV, not read them out.
You determine the success of your programming by observing
the actual change of the setting in action.
11.3 Programming on the Programming track
In section 13.12 the reasons for using service mode programming
were explained. In this section you will learn about the various
methods for using service mode programming using a special
programming track. For programming the locomotive address and the
other key settings we have created a very convenient method.
11.3.1 What is a programming track?
Using “Programming on the programming track” it is not necessary to
know the address of the decoder. In this approach, the decoder will
receive for example this command:
"Enter the value 15 in CV4!"
To be sure that only one particular decoder receives the programming
command, you must make sure that when you are programming on
the programming track only this one decoder is will receive this
command. This is most easily done by using a track that is
1. electrically isolated from the rest of the layout, and
2. on which you place only the desired locomotive you wish to
program.
11.3.2 Where is the programming track / the decoder
connected?
The command station LZ100 has special connection terminals for the
programming track. These connections are labeled P and Q. More
information about them is found in the operation manual for command
station LZ100.
