Information LH100 V3.6
41
Press the ‘Cl’ key to clear the error message from the display and
return to locomotive control.
9
Throwing turnouts and setting signals
In this section you learn how to control turnouts or signals
With the turnout control function you can use the hand held controller
LH100 to throw turnouts, set signals or for instance activate relays.
For this to work, these devices must be connected to accessory
decoder LS100/110/120 of the
Digital plus by Lenz
®
system or to other
compatible NMRA DCC accessory decoders.
Proceed as follows:
Press
On the display you see
Explanation
Display shows the most
recently selected menu
Enter the number of the turnout (the
magnetic device) that you want to
actuate.
If needed you can use the ‘Cl’ key to
correct your entry
The valid entry range is 1 to 1024. If you
enter a lower or higher value, then you
will again be prompted to enter a
turnout address.
Following the number (address) of the
turnout will now appear a + or - to show
the status of the turnout (or signal).
Use the ‘+’ or ‘-’ keys to change the
status of the turnout (or other device
connected to the accessory decoder).
The changed status is shown.
If you now want to throw another turnout, then press the ‘Cl’ key and
enter the new number of the turnout (or signal) that you now want to
actuate.
