Lenovo ThinkServer TD350, User Manual And Hardware Maintenance Manual

Page: 153 / 226

Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
• Ensure that you install the correct type of microprocessor option your server supports. When two
microprocessors are installed, both must have the same core voltage and core speed.
• Use any documentation that comes with the microprocessor option kit and follow those instructions in
addition to the instructions in this topic.
• Your microprocessor, socket, and socket cover might look slightly different from the illustrations in this
topic.
To install the second microprocessor, do the following:
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server. If
the server is in tower form factor, lay the server on its side for easier operation.
3. Remove the server cover. See “Removing the server cover” on page 72.
4. Remove the cooling shroud. See “Removing the cooling shroud” on page 75.
5. Locate the microprocessor socket 2 on the system board. See “System board components” on page 47.
6. Open the small handle 1 first by gently pressing down the handle a little bit and then pushing the handle
inward to release it from the secured position. Then, open the other small handle 2 in the same way.
Note: There are two marks on the microprocessor retainer. Open the small handle marked with
first and then open the other small handle marked with . Always follow the correct sequence when
you open the small handles.
Figure 99. Opening the handles
Chapter 6
.
Replacing hardware
139