Lenovo THINKSERVER 387, Hardware Maintenance Manual

Page: 182 / 248

Note: For safety consideration, be sure to use a tool, for example a screwdriver, to tighten the
thumbscrew and always make sure that the thumbscrew is securely installed. Also, do not over-tighten
the thumbscrew.
7. Lock the server cover and server front door to ensure the security. See “Server locks” on page 22.
8. Reconnect external cables and power cord(s) to the server. See “Rear view of the server” on page 19 to
identify the connectors on the rear panel of the server.
Attention: To avoid component damage, connect the power cord(s) last.
Note: In most areas of the world, Lenovo requires the return of the defective CRU. Information about this will
come with the CRU or will come a few days after the CRU arrives.
Updating the server configuration
When you turn on the server for the first time after you install, remove, or replace a device, you might
need to update the server configuration.
Some optional devices have device drivers that you must install. For information about installing device
drivers, use the documentation that comes with each optional device. To obtain the supported device drivers
for your server from the Lenovo Support Web site, go to http://support.lenovo.com. Click
Download Drivers
& Software and follow the instructions on the Web page to find the device drivers you want to download.
Refer to the following information resources to update the server configuration:
• To update the BIOS configuration, see “Using the Setup Utility program” on page 55.
• To update the RAID configuration, see “Configuring RAID” on page 71.
• To use the ThinkServer EasyStartup program, see “Using the ThinkServer EasyStartup program” on
page 69.
• To update your system firmware, see “Updating the firmware” on page 80.
170
ThinkServer Hardware Maintenance Manual