Lenovo 7099U1U, Hardware Maintenance Manual

Page: 59 / 224

Diagnostic Error Code FRU/Action
018-250-XXX PCI Card Services error 1. PCI card
2. Riser card, if installed
3. System board
020-000-XXX PCI Interface Test Passed No action
020-0XX-XXX PCI Interface error 1. PCI card
2. Riser card, if installed
3. System board
020-195-XXX PCI Test aborted by user Information only Re-start the test, if necessary
020-196-XXX PCI test halt, error threshold exceeded 1. Press F3 to review the log file
2. Re-start the test to reset the log file
020-197-XXX PCI test warning 1. If a component is called out, make sure it is connected
and/or enabled. See Chapter 6 “Using the Setup
Utility” on page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
020-198-XXX PCI test aborted
1. If a component is called out, make sure it is connected
and/or enabled. See Chapter 6 “Using the Setup
Utility” on page 39
2. Flash the system and re-test. See “Updating (flashing)
the BIOS from a disc” on page 209
3. Go to “Undetermined problems” on page 65
020-199-XXX PCI test failed, cause unknown 1. Go to “Undetermined problems” on page 65
2. Flash the system and re-test. See “Updating (flashing)
the BIOS from a disc” on page 209
3. Replace component under function test
020-262-XXX PCI system error 1. PCI card
2. Riser card, if installed
3. System board
025-000-XXX IDE interface Test Passed No action
025-00X-XXX 025-01X-XXX IDE interface failure 1. IDE signal cable
2. Check power supply voltages
3. Reseat IDE signal cable
4. IDE device
5. System board
025-027-XXX IDE interface Configuration/Setup error
1. IDE signal cable
2. Flash the system. See “Updating (flashing) the BIOS
from a disc” on page 209
3. Reseat IDE signal cable
4. IDE device
5. System board
Chapter 7
.
Symptom-to-FRU index
53