Lenel DirecDoor, Installation Manual

Page: 15 / 90

DirecDoor Installation Guide
15
CHAPTER 2
Installation, Planning, and Mounting
Read these instructions and all supporting documentation entirely before installing or operating this
product. A qualified service person, complying with all applicable codes, should perform the
hardware installation.
Note: We recommend that you configure DirecDoor controllers before field deployment. This
means you should define your network addressing scheme prior to installation, bench
configure your DirecDoor controllers following the networking scheme, and identify
the DirecDoor controller externally, then proceed with on-site installation.
The following is a basic outline for installing and setting up your DirecDoor system. Some steps may
have been done for you depending on what you ordered. Some steps are optional, depending on the
additional equipment you plan to use. These steps are noted.
• WARNING! • Do not apply power to any component until the installation is complete.
Damage to components may occur if power is incorrectly applied.
1.
Determine the cable clamps needed and obtain them before starting the installation.
During the installation, remember to:
•
Label all connections/cables for ease of maintenance.
•
Leave enough slack in the wiring so the cables can be “dressed.” This minimizes
interference during board removal or replacement.
2.
Unpack your system. Refer to Introduction on page 9.
3.
Mount the enclosure. Refer to Mounting on page 17.
4.
If required, mount and install one of the following:
•
PoE power supply. Refer to Installing the PoE (Power over Ethernet) on page 24.
•
Auxiliary power supply with battery backup. Refer to Installing the Auxiliary Power Supply
on page 25.
5.
Verify that your network is up and running.
6.
Install and wire up the DirecDoor board. Be sure to configure and verify the jumpers. Plug in the
network cable. Refer to
DirecDoor Board on page 27 .
7.
Wire the readers to the controller. Be sure to configure and verify the switch settings and
jumpers. Refer to
Reader Interface on page 37 .