Lenel DirecDoor, Installation Manual

Page: 72 / 90

Controller Firmware Tools
72
DirecDoor Installation Guide
IMPORTANT:
To ensure the security of the controller after configuration is complete, disable
the ICT. If the controller requires configuration updates after initial
configuration, re-enable the ICT. Disable the ICT only if necessary. For more
information, refer to
Disable/Enable the Integrated Configuration Tool (ICT)
on page 72 .
•
Disable Telnet/FTP: Check this box to disable Telnet/FTP functions.
•
F/2F Reader DOOR CONTACT/REX Input Source:
–
Reader Edge : Door contact and REX are wired to reader, door junction box, or Wiegand
Interface Unit (WIU).
–
Board Edge : Door contact and REX are terminated into inputs at the controller.
Disable/Enable the Integrated Configuration Tool (ICT)
Note: Disabling the ICT prevents access to the configuration parameters for the controller.
Disable the ICT only if necessary.
To disable the ICT:
1.
Log into the ICT.
Refer to Connecting and Starting the Tool on page 65 .
2.
From the Controller Parameters menu, select Other Parameters .
3.
Check the Disable Integrated Configuration Tool box and click OK .
4.
To permanently disable the ICT, click Save .
The ICT web page closes and the ICT is permanently disabled.
To enable the ICT:
Note: The Watchdog LED (D19) flashes once per second to indicate that the controller is in
Normal Operation Mode.
1.
Press and hold the SW4 (Boot Mode) switch and wait while D19 completes the following
sequence:
a.
D19 turns ON for approximately three (3) seconds
b.
D19 turns OFF for one (1) second
c.
D19 starts flashing once per second, indicating that the controller is in Normal Operation
Mode.
2.
Release the SW4 switch. The ICT is enabled.
Upgrading the Controller Firmware
Note:
Once the controller has the initial NGP-CASI firmware loaded (using ICT), you must
use Alarm Monitoring (not ICT) to upgrade to subsequent versions of the NGP-CASI
firmware.
• WARNING! •
Do not reset or restart the controller in the middle of the flash process or the
controller will become nonfunctional.
1.
Open the OnGuard Alarm Monitoring application and select the controller you are planning to
flash or upgrade in the main Alarm Monitoring window.