Lenel DirecDoor, Installation Manual

Page: 29 / 90

DirecDoor Installation Guide
29
Switches and Jumpers
Switches and Jumpers
Switches
Connectors
Switches
Switch Purpose
SW1 – Reader Technology
and Supervised DI/REX Refer to table Reader Technology (SW1-1 through SW1-4) on
page 37 and table Supervised DI/REX on page 38.
SW2 – 4-position Set all to OFF.
SW3 – RS485 configuration Refer to table SW3 (not applicable to the DDSDC) on page 29.
The DDSDC does not support RS485 communication.
Switches SW4 through SW7 are right-angle momentary contact push buttons.
SW4 – Boot Mode This function manually enables the Integrated Configuration
Tool.
To enable the Integrated Configuration Tool:
•
Press and hold SW4 until D19 (Watch dog LED) turns ON.
Allow up to five (5) seconds for D19 to turn ON.
•
Once D19 is ON, release SW4. D19 turns OFF once the
Integrated Configuration Tool has been manually enabled.
SW5 – Hardware Reset Reboots the DirecDoor board. The switch should only be used
when performing a controlled manual shutdown of the application if
instructed to do so by Technical Support.
SW6 – Shutdown request See Safe Shutdown Procedure for the DirecDoor Board on page 35 .
SW7 – Restore Defaults Returns the configuration to the factory defaults:
•
Primary Connection Type: Ethernet
•
IP Address: 192.168.6.6
•
Mask: 255.255.255.0
•
Gateway: 192.168.6.1
Press SW7 for a minimum of five (5) seconds, then release.
SW3 (not applicable to the DDSDC)
SW3-
120 ohms transmit pair termination 1 ON
No transmit pair termination (default) 1 OFF
120 ohms receive pair termination 2 ON
No receive pair termination (default) 2 OFF
RS485 - 4 wire (default) 3, 4 OFF
RS485 - 2 wire 3, 4 ON