42
FNC Key
Leica TPS800-4.0.0en
T_Off: Length offset
L_Off: Cross offset
Height : Offset point is higher than measure-
ment
Procedure:
1. Enter the offset values (length, cross and/or
height) as per the sketch.
2. Define the period for which the offset is to apply.
3. [RESET]: Sets eccentricity to zero.
4. [SET]: calculates the corrected values and
jumps to the application from which the offset
function was started. The corrected angle and
distances are displayed as soon as a valid
distance measurement has been triggered or
exists.
The period of applicability can be set as follows:
)
The offset values are always reset to 0 when
the application is quit.
Cylinder Offset subapplication
Use [CYLNDER] to determine the coordinates of the
centre point of cylindrical objects and their radius.
Measure the horizontal angle to a point on the left
and on the right side of the object as well as the
distance to the object.
RESET
CYLNDER
OK
Enter offset values!
Trav. Offset:
0.600 m
Length Offset:
0.800 m
Height Offset:
0.500 m
Mode :
Reset after REC
Reset after REC
The offset values are reset to 0
after the point is saved.
Permanent
The offset values are applied to all
further measurements.