116
Programs
Leica TPS800-4.0.0en
suitable when the precision of the angles and
distances are approximately equal.
•
Transit rule
If you select Transit Rule the coordinate misclo-
sure will be distributed with respect to the coor-
dinate changes in Easting and Northing. Use
this method if the angles were measured with a
higher precision than the distances.
To begin a traverse you may:
•
Start a traverse without a known backsight
•
Start a traverse with a known backsight
If the coordinates of the start station are unknown,
the Free Station application can be run before and
by choosing "Start a traverse without a known back-
sight" the system azimuth can be overtaken.
If the start azimuth is unknown and a Helmert trans-
formation is performed in the end, then also use
"Start a traverse without a known backsight".
It is also possible to observe sideshots and check
points during the traverse. However check points
are not included in the traverse adjustment.
At the end of the traverse, results are displayed and
optionally an adjustment can be calculated.
Start on known point with known azimuth
Stop on known point and optionally measure to
a known closing point
C1, C2, C4, C5
Control Points
C3
Check Point
P1...P3
Traverse Points
TP1...TP3
Topographic Points
N
North Direction
TPS800_Z150
C1
C2
P1
P2
P3
C4
C5
TP3
TP2
TP1
C3
N
N
