Detailed guide /
Record mode
/ 145
• For SCA-3002 standard flash units:
1. To retain the automatic flash exposure control,
an SCA-3502 M4 adapter is needed.
2. It must be possible to set the flash unit to a
mode that allows the camera’s guide number
calculation to control the flash power (Guide
Number Control, see the relevant flash instruc-
tions).
• For all other SCA system flash units and earlier
adapters than the SCA-3502 M4:
1. The flash unit must be set to
A
or
M
.
2. For
M
, the reduced power output must be deter-
mined by guide number calculation and set
manually on the flash unit.
• For non-SCA flash units:
1. The only available flash modes are manual flash
activation and deactivation (
H
/
G
).
2. Only the exposure modes
A
and
M
can be used
on the camera.
3. The flash unit must be set to
A
or
M
. For
M
, the
reduced power output must be determined by
guide number calculation and set manually on
the flash unit. For
A
, the aperture settings on the
camera and the flash unit must be the same.
• For indirect flash (rotated or tilted flash reflector),
the flash unit must be set to
A
mode.
• Do not use a cover for the flash shoe, as this will
mechanically switch off the internal flash, and pre-
vent it from being folded out.
Important:
• If an external flash unit is attached, it must also be
turned on, i. e. ready to use, otherwise incorrect
exposures and incorrect messages on the camera
may result.
• If, on the other hand, you want to take pictures with
a flash unit attached and turned on but without
actually using the flash, the flash mode on the
camera must be turned off.
Summary of Contents for Digilux 2
