LaserStar iWeld 900 Series, Operation & Maintenance Manual

Page: 115 / 172

LaserStar
®
Workstation Operation & Maintenance Manual 900 Series Ver. 991.6 November 2019
115
Step 15 / Figure 15
(Carefully place the pump chamber back into the laser rail.
Attention: Do not bump the rear mirror assembly
.)
Figure 15
(Install the Pump Chamber with Screws (3) to the Laser Rail)
Step 16 / Figure 16
(Position the pump chamber against the rail reference edge
and then the end stop. Before tightening the pump chamber screws move the
pump chamber forward off the end stop by ~010” and then use an M4 hex key
wrench to tighten the (2) front screws. The back screw should be snug and not
overtightened.
Figure 19
(Position Pump Chamber Assembly against End Stop & Rail Reference Edge)
Carefully
place the
Pump Chamber
Assembly back in
the Laser Rail up
against the End
Stop. Put the screws
that retain the Pump
Chamber to the rail
in one at a time
locate the retaining
nut in the rail. This
may take a few tries,
be patient.
Do not
tighten screws at
this time.
2.
Push Pump
Chamber back
against End
Stop & then
move off the
end stop by
~.010”
Screw
End Stop
Reference
Edge
1.
Push Pump
Chamber
against
Reference
Edge of rail as
shown by the
two arrows.
ATTENTION-
Make sure
Pump
Chamber is
sitting flat on
rail surface.
3.
Tighten the
(2) front pump
chamber
screws using
and M4 hex
key wrench
Screw
Screw
End Stop
Do not bump
rear mirror
assembly
4. This pump
chamber
screw should
be snug, not
to tight.