LaserStar iWeld 900 Series, Operation & Maintenance Manual

Page: 114 / 172

LaserStar
®
Workstation Operation & Maintenance Manual 900 Series Ver. 991.6 November 2019
114
Step 13 / Figure 13
(Position the flashlamp assembly such that the each end of
the flashlamp (plastic body/insulator) extends equally ( ) on both ends of the
pump chamber.)
Figure13
(Flashlamp Installed)
Step 14 / Figure 14
(Tighten the end cap screws on
both
ends of the pump
chamber assembly and verify that each end of the flashlamp extends equally.
Note:
Red wire end shown)
Figure 14
(End Cap Screws Tightened on Both Ends of the Pump Chamber)
End Cap
Screw
End Cap
Screw
ATTENTION:
Do
not overtighten the
End Cap Screws
Flashlamp
extends same
amount on
each end.
Flashlamp
extends same
amount on
each end.