9: Service Settings
XPort Pro User Guide
69
SNMP Settings
Simple Network Management Protocol (SNMP) is a network management tool that monitors
network devices for conditions that need attention. The SNMP service responds to SNMP
requests and generates SNMP Traps.
This page is used to configure the SNMP agent.
To configure SNMP:
1. Click
SNMP
on the menu bar. The SNMP page opens and shows the current SNMP
configuration.
Figure 9-4 SNMP Configuration
2. Enter or modify the following settings:
Table 9-5
SNMP
SNMP Settings
Description
State
Select
Enabled
to enable SNMP.
Read Community
Enter the SNMP read-only community string.
Write Community
Enter the SNMP read/write community string.
System Contact
Enter the name of the system contact.
System Name
Enter the system name.
System Description
Enter the system description.
System Location
Enter the system location.
Traps State
Select
Enabled
to enable the transmission of SNMP Traps.
The Cold Start trap is sent on device boot up, and the
Linkdown trap is sent when the device is rebooted from
software control.
Traps Primary Destination
Enter the primary SNMP trap host.
