6: Line and Tunnel Settings
XPort Pro User Guide
35
2. Enter or modify the following settings:
Table 6-5
Line 1 Command Mode
Line Command Mode
Setting Command Mode
enables the CLI on the serial
line.
To configure Line 1
Command Mode:
1. Click
Line 1 > Command
Mode
at the top of the
page. The Line 1
Command Mode page
appears.
Figure 6-4 Line 1 Command Mode
Line – Command Mode
Settings
Description
Mode
Select the method of enabling Command Mode or choose to disable
Command Mode.
Always
= immediately enables Command Mode for the serial line.
Use Serial String
= enables Command Mode when the serial string is
read on the serial line during boot time.
Use CP Group
= enables Command Mode based on the status of a CP
Group. When the value matches the current value of the group,
Command Mode is enabled on the serial line.
Use both Serial String and CP Group
= the serial string and the value of
the CP group must be matched to enable Command Mode.
Disabled
= turns off Command Mode.
Wait Time
Enter the wait time for the serial string during boot-up in milliseconds.
Note:
The
CP Group
option
displayed in the screenshot is
only supported in XPort Pro
and XPort AR.
