6: Configuration via Serial Mode or Telnet Port
WiPort Embedded Wireless Device Server User Guide
59
Auto Increment Source Port
Auto increment source port (N) ? _
Y
(Yes) auto increment the source port. The WiPort increments the port number used
with each new connection.
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote IP Address : ( 0) ( 0) ( 0) ( 0)_
Note:
This option is not displayed when Hostlist is enabled from the
ConnectMode
prompt (see page 52 for more information).
Remote Port
Set the remote TCP port number for the unit to make outgoing connections. This
parameter defines the port number on the target host to which a connection is
attempted.
Remote Port ( 0) ? _
To connect an ASCII terminal to a host using the unit for login purposes, use the
remote port number 23 (Internet standard port number for Telnet services).
Note:
This option is not displayed when Hostlist is enabled from the
ConnectMode
prompt (see page 52 for more information).
DisConnMode
Disconnect Mode (DisConnMode) determines the conditions under which the unit will
cause a network connection to terminate. The current value is displayed in
parentheses.
DisConnMode ( 0) ? _
In DisConnMode, modem_control_in either drops the connection or is ignored. The
following table displays the available input options:
Table 5-12. Disconnect Mode Options
Disconnect Mode Option
7 6 5 4 3 2 1 0
Disconnect when Modem
Control In is not asserted
(6)
1
Ignore Modem Control In
0
Telnet Com Port Cntrl and
terminal type setup
(1)
1
Channel (port) password
(2)
1
Hard disconnect
(3)
0
Disable hard disconnect
1
State LED off with connection
(4)
1
Disconnect with EOT (^D)
(5)
1
