Lantronix EMG 7500, User Manual

Page: 315 / 482

14: User Authentication
EMG™ Edge Management Gateway User Guide 315
Authentication
Service
The type of service used to pass the authentication tokens (e.g., login and
password) between the EMG and the server. Options are: ASCII
Login (login and password are transmitted in clear, unencrypted text), PPP/PAP
(login and password are transmitted in clear, unencrypted text via a PAP protocol
packet), and PPP/CHAP (the server sends a challenge that consists of
a session ID and an arbitrary challenge string, and the user name and password
are encrypted before they are sent back to the server). PPP/PAP is the default.
Service The service to use when sending a authorization message to the
server to obtain an authenticated user's priv_lvl. The priv_lvl is used to assign a
EMG custom group to the authenticated user for permissions and port rights (see
Groups). Suggested values are "slip", "ppp", "arap", "shell", "tty-
daemon", "connection", "system" and "firewall". The default is "shell".
Protocol The optional protocol associated with the Service, which is included in the
authorization message sent to the server to obtain an authenticated
user's priv_lvl. The priv_lvl is used to assign a EMG custom group to the
authenticated user for permissions and port rights (see Groups).
Suggested values are "lcp", "ip", "ipx", "atalk", "vines", "lat", "xremote", "tn3270",
"telnet", "rlogin", "pad", "vpdn", "ftp", "http", "deccp", "osicp" and "unknown".
Timeout The timeout in seconds when attempting to connect to a server.
Timeout range is 1 to 10 seconds. 5 seconds is the default.
Custom Menu If custom menus have been created (see Custom User Menu Commands ), you
can assign a default custom menu to users.
Escape Sequence A single character or a two-character sequence that causes the EMG to leave
direct (interactive) mode. (To leave listen mode, press any key.)
A suggested value is
Esc+A (escape key, then uppercase "A" performed quickly
but not simultaneously). You would specify this value as \ x1bA , which is
hexadecimal ( \ x ) character 27 ( 1B ) followed by an A .
This setting allows the user to terminate the
connect direct
command on
the command line interface when the endpoint of the command is
deviceport
,
tcp
, or
udp
.
Break
Sequence
A series of 1-10 characters users can enter on the command line interface to send
a break signal to the external device. A suggested value is Esc+B (escape key,
then uppercase “B” performed quickly but not simultaneously). You would specify
this value as \ x1bB , which is hexadecimal ( \ x ) character 27 ( 1B ) followed by a B .
See
Key Sequences
for notes on key sequence precedence and behavior.
Enable for Dial-back Select to grant a user
Dial-back
access. Users with dial-back access can dial into
the EMG unit and enter their login and password. Once the EMG authenticates
them, the modem hangs up and dials them back. Disabled by default.
Dial-back Number The phone number the modem dials back on depends on this setting for the
device port. The user is either Dial-back on a fixed number, or on a number that is
associated with the user’s login (specified here).
Data Ports The ports users are able to monitor and interact with using the connect direct
command. U1 denotes the USB port on the front of the EMG unit.
Listen Ports
The ports users are able to monitor using the
connect listen
command.
Clear Port Buffers
The ports whose port buffer users may clear using the
set locallog
clear
command.