47
Elevation Motor Removal & Installation:
Step 3
Underneath the motor pan, use the 5/8” wrench to remove the nut and bolt connecting the elevation shaft to the leg
assembly, as shown in
Illustration E
. Remove the elevation motor, as shown in
Illustration F
.
Step 4
To Install, reverse the steps shown here to finish installation.
It is recommended to partly tighten the trunnion bolt
first, as shown in
Illustration G
. Then, adjust the shaft of the elevation motor to align with the holes in the elevation
leg assembly, as shown in
Illustration H
. Next, slide the bolt through the elevation legs and then tighten fully.
Finally, return to the trunnion bolt and finish tightening, as shown in
Illustration I
.
Calibrating the Elevation Motor
To calibrate the elevation motor:
Start the machine. Pull out the Safety Key, as shown in
Illustration J
, until the
display shows the version #, as shown in
Illustration K
. Push the safety key back in, and hold the
I
and
Speed +
buttons, until the screen changes to Auto Adjust, as shown in
Illustration L
. The auto calibration process
will then begin.
CAUTION- The Treadmill will incline and decline by itself during this process!
E
F
G
H
I
J
K
L
Summary of Contents for L10
