46
Elevation Motor Removal & Installation:
Elevation Motor Installation/Removal Instructions
INTRODUCTION:
This document is for installation and removal of the Elevation Motor (#10064).
WARNING: THIS IS A HIGH AC VOLTAGE SO BE SURE TO UNPLUG THE TREADMILL
TOOLS REQUIRED:
13mm Socket Wrench
5/8” Wrench
Phillips Head Screwdriver
BEFORE YOU BEGIN:
Please turn off and remove power from the treadmill before removing or
installing parts. It is also helpful to have something to prop up the front of the treadmill before removing
and installing the Elevation Motor.
Step 1
Place a block or something solid underneath the front of the treadmill, allowing you access to underneath
the motor pan, as shown in
Illustration A
. Then, disconnect the elevation harness connector from the
Lower Board (Inverter)
as shown in
Illustration B
.
Step 2
Using the Phillips head screwdriver, remove the screw securing the harness cable to the motor pan, as
shown in
Illustration C
. Then, use the 13mm socket wrench to hold the nut in place, and use the 5/8”
wrench to remove the bolt, as shown in
Illustration D
.
A
B
C
D
Summary of Contents for L10
