17
5. In the “Update from USB” section, tap the
Software
button.
The screen will automatically conduct a power cycle
once the update is complete. Wait at least ten (10)
seconds before accessing the Service Menu once the
power cycle is complete.
NOTE
6.
Verify that the correct update is displayed on the screen then
tap
Start Update
.
Update Software
1. Load the
.update
file on to any USB formatted to “FAT32” as
shown in the image below.
2. Lift screen to access PCB on back of screen.
3. Plug the USB into open port on the side of the PCB
controller box.
4. Access the Service menu on the left side screen and tap the
Data Management
button.
Update Brands/Flavors
1. Create a USB drive with the updated
.brand
file in a folder
named “brands” as shown in the image below.
2. Lift screen to access PCB on back of screen.
3. Plug the USB into open port on the side of the PCB
controller box.
4. Access the Service menu on the left side screen and tap the
Data Management
button.
Software
Brands
L’écran effectuera automatiquement un cycle d’ali
-
mentation une fois la mise à jour terminée. Attendez
au moins dix (10) secondes avant d’accéder au menu
Service une fois le cycle d’alimentation terminé.
REMARQUE
