11
25. Activate each valve to purge air from the syrup lines.
Adding New Brand/Flavor Modules
1.
In order to use a brand or flavor module, the module must
first be configured.
2. From the Service menu, tap the
Valve Configuration
button.
5. Select a brand group from the Available Brands column. The
list of available brands will change to reflect what’s in the
group you selected. Tapping on a brand icon will select it for
the valve being configured.
Each brand has a default water type and ratio already
set when they are selected. The water type and ra-
tio can be adjusted if necessary. Adjust the ratio by
tapping “Use Custom Ratio“, and entering the new
value on the keypad.
NOTE
3.
From the Valve Configuration menu, tap any brand or flavor
module to open its Configuration Page.
6.
Once a brand/flavor has been selected for a corresponding
module, tap the back button on the lower left corner to return
to the Valve Configuration Screen.
7.
Repeat Steps 3 and 5 for any of the other brand or flavor
modules.
8.
Tap the Back button to return to the Service menu.
12. Tap the Back button to return to the Service Menu.
9. From the Service Menu, tap the Maintenance button.
10. Tap the
Purge
tab at the bottom of the screen.
11.
Purge any new brand or flavor module until there is a steady
flow of syrup. (See previous page)
4. Tap the “Brand“ or “Flavor“ tab at the top of the screen to set
the selected valve as a brand or flavor.
Pour vérifier la présence de fuite de CO
2
, fermer la valve
de la bouteille de CO
2
pour déterminer si la pression du
système chute dans un délai de cinq minutes.
Ouvrir la valve de la bouteille après la vérification.
NOTE
Chaque marque a un type d’eau et un rapport par
défaut déjà définis lorsqu’ils sont sélectionnés. Le type
et le rapport d’eau peuvent être ajustés si nécessaire.
Ajustez le rapport en appuyant sur “Utiliser le rapport
personnalisé” et en entrant la nouvelle valeur sur le
clavier.
REMARQUE
