1.2 DRAIN SPIDER
The drain spider is located directly in the center of the bin under the ice shroud. The
coldplate has a cavity designed to hold the drain spider. During shipment or instal-
lation, the drain spider may become dislodged from its original position.
Prior to installing the dispenser, ensure the drain spider is in the correct position.
This will prevent drain clog issues. Inspect the lower bin area and reach under the
shroud to ensure the drain spider is secure in the coldplate cutout. If the spider is
not in place, proceed with the following steps:
A. Remove agitator clip and pin from agitator bar.
B. Remove agitator bar from paddle wheel.
C. Remove paddle wheel.
D. Remove ice shroud by lifting back then out of bin.
E. Locate drain spider and reinstall in the coldplate cavity where drain line exits
(see figure above).
F. Reinstall all components. Ensure agitator clip is locked:
10
P.N. 28-0580/02
