LEVELING THE DISPENSER:
In order to facilitate proper dispenser drainage and carbonation, ensure that the
dispenser is level, front to back and side to side. Place a level on the top of the rear
edge of the dispenser. The bubble must settle between the level lines. Repeat this
procedure for the remaining three sides. Level unit if necessary.
FS22 DISPENSER WITH ICEMAKER:
Install
the icemaker per manufacturer specifications. Points of consideration include
drainage, ventilation, and drop zones.
An adapter plate
is required when installing an icemaker. Contact your Sales
Representative or Lancer Customer Service for more information.
A bin thermostat
is required in order to control the level of ice in the dispenser. Contact
your icemaker manufacturer to obtain the correct bin thermostat.
Ensure
the icemaker is installed properly to allow for removal of the merchandiser.
Ensure
manual fill is accessible.
Clean and maintain
icemaker per manufacturer’s instructions.
ENSURE SUFFICIENT CLEARANCE
FOR FILLING WITH ICE
FS22 DISPENSER, NO ICEMAKER
ENSURE KEYSWITCH
IS ACCESSIBLE
9
P.N. 28-0580/02
