E. Fill a cup with clean warm water and rinse nozzle body.
F. Make certain that the nozzle o-ring is not torn or otherwise damaged. If
necessary, replace damaged o-ring with Lancer PN 02-0231.
G. Wet the inner surface of the nozzle housing with water and reinstall the nozzle
housing by sliding it over the nozzle body and turning clockwise to lock in
position.
2.4 ICE BIN CLEANING - PERFORM AT STARTUP AND MONTHLY
A. Disconnect power to the dispenser.
B. Remove the top cover.
C. Melt out any remaining ice from the bin.
D. Remove the splash plate, drip tray and front and rear bin covers.
E. Remove the agitator pin from the agitator shaft. Slide the agitator shaft rearward
out of the motor shaft and pull out of the rear bearing to remove.
F. Remove the dispensing wheel from the motor shaft by sliding rearward.
CONTINUED ON NEXT PAGE
19
P.N. 28-0580/02
