background image

PAGE 1 OF 2 

0721 IH-2274

1-800-295-5510

uline.com

AUTOMATIC PAPER 
TOWEL DISPENSER

H-2274

MOUNTING

Mount dispenser securely on wall with supplied 

hardware. Bottom edge should be approximately 52 

inches above the floor.

OPENING THE COVER

Key is taped to back of dispenser. 

1.  Insert forked end of key into two slots at top of cover. 

2.  Push down on key and pull forward on cover.

Note: Opening the cover removes battery 
power from control circuit.

LOADING BATTERIES

1.  Open cover. Push left-hand tab on battery 

compartment inward and lift up. (See Figure 1)

2.  Insert four "D"-size alkaline batteries with "LR20" 

designation. (Battery orientation is embossed on 

compartment.

Note: We do not recommend using 
rechargeable "D"-size batteries.

LOADING PAPER ROLL

1.  Open cover and load paper roll with paper "tail" 

unwinding from back of roll. Place paper "tail" under 

transfer bar arm. (See Figure 2, A)

2.  Close cover and move hand under unit to activate 

dispense. Unit initially dispenses at factory-set 

control settings. (See Figure 2, B)

LOADING STUB ROLL TRANSFER 

To use this feature, the 3-inch or smaller stub roll must 

be transferred from upper roll holders to stub roll holders 

in rear, lower section. Stub roll paper monitor must be 

positioned over stub roll paper "tail."

1.  Insert new paper roll in upper roll holders. Place "tail" 

of new paper roll on top of stub roll paper monitor 

and under transfer bar arm. (See Figure 3, A-C)

2.  Paper from new roll will automatically feed when 

stub roll of paper runs out.

OPERATION

STUB-ROLL PAPER MONITOR

TRANSFER BAR ARM

BATTERY COMPARTMENT

B

A

A

B

C

 Figure 1

 Figure 3

 Figure 2

Reviews: