O
PERATION
OF
THE
R
APIDS
™
Failure to follow the instructions and warnings mentioned in this manual will result in the
inability to maintain safe operation.
Unit is equipped with a timed dispense option. User must be aware of flow rate of water
so as not to overfill containers and cause spills onto a bench or floor.
T
URNING
ON
THE
R
APIDS
™
UNIT
To turn on the Rapids™ Unit, ensure that the power supply cable is first
plugged into the power source and the Rapids™ unit . Refer to installation
requirements for power specifications.
Toggle the power switch up to turn on the unit.
The unit will take about a minute to fully power on and show the display.
D
ISPENSING
W
ATER
FROM
THE
R
APIDS
™
UNIT
From the home screen, put the unit into ‘ON’ mode. Water can not be
dispensed from ‘IDLE’ or ‘OFF’ mode.
Press the dispense button then slide your finger to the ‘PRESS AND HOLD’
button.
Hold this button to dispense water manually or slide your finger up to se-
lect a timed dispense option.
Time may be added until desired dispense time is reached by pressing
either the 30 second, 1 minute or 3 minute buttons once or multiple
times.
After a couple seconds the screen will lock and only the ‘STOP’ button
will be able to be pressed.
Water will stop dispensing in the timed dispense mode once the time is
completed. A count down display is shown along with a ‘water filling’
progress graphic on the background of the display. Blue water back-
ground will fill the screen to show progress of time remaining of the
dispense. Once the screen is full, dispense will stop.
To stop water during timed dispense, press the “STOP’ button.
LT0033-4
Page 38
Image 5.1
Image 5.2
Image 5.3
Image 5.4