12) L-NEP LOGIC BOARD
PART DESCRIPTION
Connector J7
= WR5MS wiring for Master Slave communication in two-leaf swing door.
For more information, refer to "DOUBLE LEAF DOOR SET" paragraph.
Connector J8
= encoder wiring insertion.
Connector J10 = wiring of electric signals from connector J4 of PWN-T module.
Connector J11 = wiring of motor power supply from connector J5 of PWN-T module.
Connector J12 = insertion for EN/RF1 radio receiver.
For more information, refer to "EN/RF1 radio receiver" paragraph.
Jumper J13
= it selects the logic status of safety sensor monitoring signal.
For more information, refer to "Safety sensors" paragraph.
Connector J14 = motor wiring insertion.
Jumper J15
= it selects two speed levels for door closing without power supply.
For models with LET and SLT closing spring only.
Jumper J15 activated = low speed.
Jumper J15 deactivated = high speed.
Led 3 – Led 4 = display of encoder signals.
Led 5
= display of MP1 microcontroller operation (micro A):
led on = correct operation;
led off or slowly flashing = fault on logic board.
Buzzer
= warning buzzer.
MP1
= microcontroller “A”
Mp2
= microcontroller “B”
SW1
= dip-switch for operator type selection:
1 OFF / 2 OFF = single leaf operator or Master operator in double leaf
1 ON / 2 OFF = Slave operator in double leaf
13) N-DSEL DIGITAL PROGRAMMER – SCOPE AND CONNECTIONS
N-DSEL digital programmer is a tool necessary to the installer to configure the
operation of the automatic door and perform the set-up of operations, functions and
parameters, to perform system diagnostics and have access to events memory
containing information on automated device and its operation.
Access to the programming menu is protected by safety technical password so that
specialized and authorized personnel only can operate on the automated device.
N-DSEL digital programmer can also be used by the final user, but only for choosing
the operating mode of automatic door; the user can also select the preferred language
and set up a user password to prevent the use of digital programmer by unauthorized
persons.
Connect N-DSEL digital programmer to PWN-T module of Neptis SMP operator by
0.5mm 4-conductor cable.
Te13V = connect to terminal 15 of PWN-T board (+13V);
Terminal - = connect to terminal 12 of PWN-T board (- GND);
Terminal A = connect to terminal 13 of PWN-T board (A);
Terminal B = connect to terminal 14 of PWN-T board (B);
For each subject-matter described in the following paragraphs the use of digital
programmer (hereinafter N-DSEL) is explained in the specific case.
B A
CN2
+13 -
22
