This document is the exclusive property of FTFM La Toulousaine and must on no account be copied. It may be modified at any time in accordance with product changes.
_N°7386
Installation_Totem operator (Sliding gate)
09/21
p.9
Place the gate
-
Gate open, press the rack and pinion on the sprocket so that the notches of the rack and pinion
coincide with the notches of the sprocket and lock the screw.
-
Unwind the gate as you go until it closes and repeat the above step until all the rack and pinion
screws are tightened.
Sprocket
Rack and pinion
Lock the screw
Adjust the rack
Guiding
rail
-
Place the gate on the guiding rail.
-
Advance it towards the Totem operator to slide
the bearings into the gate
’
s transom guide rail.
-
Check that the gate is plumb, adjust the guiding
bearings accordingly and lock them in place.
Guiding
bearings
Transom guide rail
Please note :
Check that the operator is disengaged (clutch lever in down position).
Please note² :
The height of the operator sprocket is preset at the factory.
