This document is the exclusive property of FTFM La Toulousaine and must on no account be copied. It may be modified at any time in accordance with product changes.
_N°7386
Installation_Totem operator (Sliding gate)
09/21
p.17
Please note :
A reset is only possible when the operator is locked and the 230V voltage is present
(not possible on battery function).
-
Press the START and PROG buttons
simultaneously and hold them down.
Please note :
The "Light" LED starts flashing.
-
Release the buttons while the "Light" LED is
still on.
-
Reset is complete and the LED "Light" is
flashing.
1
-
Programming button.
2.1
-
LED radio channel 1 :
Pulse mode
(Open
-
off
-
closed
-
off
-
open
-
etc
…)
2.2
-
LED radio channel 2 :
Partial opening
(Pedestrian opening)
2.3
and
2.4
-
LED radio channel 3 and 4 :
Not used
-
Press the programming button (1 time for channel 1, LED 2.1 lights up).
Please note :
If LED
2.2
,
2.3
or
2.4
lights up, continue to press until LED
2.1
is reached.
-
Select a key on the transmitter and hold it down until LED
2.1
goes out.
-
Programming in pulse mode is complete.
To program additional pulse emitters, repeat the above steps.
(112 memory entries are available).
Move gate to closed position.
Pulse mode
In case of a fault or before the self
-
learning cycle :
Reset board
Transmitter programming
Once the channel is selected, you have 10 seconds to perform the next
operation, otherwise the programming of the receiver will be cancelled.
