HM-JACKarc Operation Manual
Introduction
1 - 6
Rev.4
4. The following points must be observed after using the Instrument.
(1) Follow the set procedure to return all control switches, dials to the same positions they
had before the Instrument was used, and then turn off the power.
(2) When you disconnect any cables, do not apply any excessive or inappropriate forces on
them, such as pulling them by the cable rather than by the plug.
(3) Pay attention to the following points regarding the storage location.
i)
Store the Instrument in a location where it is not exposed to water.
ii) Store the Instrument in a location where there is no risk of adverse influence from
atmospheric pressure, temperature, humidity, drafts, sunlight, dust, air containing
salinity and/or sulfur or other environmental factors.
iii) Make sure the Instrument is safe from tilting, vibration and impact (including that
during movement).
iV) Do not store the Instrument in a location where chemical substances are stored or
where gas is generated.
(4) Clean the accessories, cables and probes.
(5) Be sure to keep the Instrument clean.
5. If the Instrument breaks down, do not attempt to fix it. Label it appropriately as "out of service" and
contact a specialist for repair.
6. Do not modify the Instrument.
7. Maintenance and inspections
(1) Inspect the Instrument and its components regularly.
(2) Before resuming use of the Instrument that has not been used for some time, be sure to
check that it operates correctly and safely.
8. In addition
The Instrument must be operated correctly, in accordance with the operation manuals.
