2LL/2LJ/2LH-1
1-4-23
(2) Self diagnostic codes
If the part causing the problem was not supplied, use the unit including the part for replacement.
Code
Contents
Causes
Check procedures/
corrective measures
0030
FAX control PWB system
error
Processing with the fax soft-
ware was disabled due to a
hardware problem.
Defective FAX con-
trol PWB.
Replace the fax control PWB
and check for
correct operation
.
0060
Illegal engine PWB type
The engine main PWB and
the engine sub PWB are
incompatible.
Defective engine
sub PWB.
Replace the engine PWB and check for cor-
rect operation (see page 1-5-47).
0070
FAX control PWB incompat-
ible detection error
Abnormal detection of FAX
control PWB incompatibility In
the initial communication with
the FAX control PWB, any
normal communication com-
mand is not transmitted.
Defective FAX soft-
ware.
Install the fax software.
Defective FAX con-
trol PWB.
Replace the fax control PWB
and check for
correct operation
.
0100
Backup memory device
error
Defective flash
memory.
Replace the main PWB and check for cor-
rect operation (see page 1-5-41).
Defective main
PWB.
Replace the main PWB and check for cor-
rect operation (see page 1-5-41).
0120
MAC address data error
For data in which the MAC
address is invalid.
Defective flash
memory.
Replace the main PWB and check for cor-
rect operation (see page 1-5-41).
Defective engine
PWB.
Replace the engine PWB and check for cor-
rect operation (see page 1-5-47).
0150
Backup memory read/write
error (engine PWB)
No response is issued from
the device in reading/writing
for 5 ms or more and this
problem is repeated 5 times
successively.
Mismatch of reading data from
2 locations occurs 8 times
successively.
Mismatch between writing
data and reading data occurs
8 times successively.
Improper installa-
tion EEPROM.
Check the installation of the EEPROM and
remedy if necessary.
Defective engine
PWB.
Replace the engine PWB and check for cor-
rect operation (see page 1-5-47).
Device damage of
EEPROM.
Contact the Service Administrative Division.
Summary of Contents for TASKalfa 3500i
