Kyocera TASKALFA 300I, Operation Manual

Page: 87 / 426

Basic Operation
3-13
3
6
If you choose [2-sided>>1-sided],
[2-sided>>2-sided], [Book>>1-sided] or
[Book>>2-sided], select the binding edge of the
originals of
Original .
7
Press [Original Orientation] to select orientation of
the originals, either [Top Edge Top] or [Top Edge
Left]. Then press [OK].
8
Press [OK].
9
Press the Start key.
Once an original placed on the platen is scanned,
replace it with the next one. Then, press the
Start
key.
After scanning all originals, press [Finish Scan] to
start copying.
Collate/Offset Copying
The machine can collate and offset at the same time as it copies.
You can use the Collate/Offset copy function for tasks such as those shown below.
Collate
Scan multiple originals and deliver complete sets of
copies as required according to page number.
Offset
Without Document Finisher
If the optional document finisher is not installed, when
you use offsetting, printed copies are produced after
rotating each set (or page) by 90º.
NOTE:
You need to load the same sized paper with
different orientation in the paper source other than the
selected paper source. The paper sizes supported in
Offset are A4, B5, Letter and 16K.
Status
08/08/2009 10:10
Ready to copy.
Copies
Cancel OK
Duplex
Add Shortcut
Book
>>2-sided
1-sided
>>2-sided
Original
Orientation
1-sided
>>1-sided
2-sided
>>2-sided
Original
Binding
Left/Right Binding
Top
2-sided
>>1-sided
Book
>>1-sided
Original
Zoom
Paper :
:
: ---
---
100%
Preview
Place original.
Top Edge Top
3
2
1
3
2
1
3
2
1
3
2
1
Original Copy
3
2
1
3
2
1
3
2
1
3
2
1
Original Copy (each set)