Kyocera TASKALFA 300I, Operation Manual

Page: 302 / 426

Default Setting (System Menu)
8-70
NOTE:
HTTP must be set to [On] in Protocol Detail on page 8-66 .
Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network , [Next] of Secure Protocol , and then [Change] of HTTPS Security .
3
Press [HTTP or HTTPS] or [HTTPS Only].
4
Press [OK].
5
After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-63 .
LDAP Security Setup
Select the type of encryption according to the type of security employed by the LDAP server. This setup is
available when
SSL is On . The default setting is Off.
NOTE:
LDAP must be set to [On] in Protocol Detail on page 8-66 .
The table below shows the available settings.
Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network , [Next] of Secure Protocol , and then [Change] of LDAP Security .
3
Press [Off], [LDAP over SSL] or [LDAPv3/TLS].
4
Press [OK].
5
After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-63 .
Item Description
Off Do not use security employed by the LDAP server.
LDAP over SSL Use implicit mode for data communication. The server provides services
using the LDAP over SSL port (636). Encryption is applied to any data
communication using this port.
LDAPv3/TLS Use explicit mode for data communication. Select this if the server supports
the start TLS command. This uses the same port (389) as LDAP.