Kyocera 6030, Operation Manual

Page: 52 / 124

Preparing to Copy
2-16
Loading Originals
Loading Originals in the Document Processor
The document processor automatically scans each sheet of multiple originals individually. Both
sides of two-sided originals are scanned automatically.
The document processor supports the following types of originals.
Precautions on Types of Originals for the Document Processor
Do not use the document processor for the following types of originals. In addition, if originals have
punched holes or perforations, load them with the holes or perforations away from the leading edge.
• Transparencies for overhead projectors
• Delicate originals such as carbon paper, crumpled paper, or vinyl sheets
• Irregularly shaped (non-rectangular) originals, wet originals, or originals containing adhesive
tape or glue
• Originals bound with clips or staples. (To avoid jams, remove the clips or staples and straighten
any curls, wrinkles, or creases before loading them. Failure to do so may cause the originals to
jam.)
• Originals with cut-out sections or with very slippery surfaces
• Originals with correction fluid which is not dried
• Originals with folds. (To avoid jams, straighten the folds before loading them. Failure to do so
may cause the originals to jam.)
How to Load Originals
Follow these steps to load originals in the document processor.
IMPORTANT: Before loading originals, be sure there
are no originals left on the original eject table. Originals
left on the original eject table may cause the new
originals to jam.
Items Specifications
Weight 45 g/m² to 160 g/m²
Size Minimum: 5
1/2
× 8
1/2
" (A5R); Maximum: 11 × 17" (A3)
Capacity Standard paper (80 g/m²), colored paper or recycled paper: 200 sheets
(30 sheets in Auto Selection mode)
Coated paper: 1 sheet
High quality paper, 50 g/m²: 200 sheets
High quality paper, 110 g/m²: 145 sheets