Kyocera Mita KM-4530, Service Manual

Page: 52 / 384

2BC/D
1-3-24
1-3-5 Installing the side deck (option)
Preparation
1. Remove the screw locking down the
developing duct cover followed by the cover.
Then, disconnect the 2-pin connector from
the cooling fan.
2. Remove the six screws locking down the
bypass table and open the table. Open the
right cover halfway and detach the middle
right cover.
3. Remove the two pins locking down the right
rear lower cover and then detach the cover by
sliding in the direction of the arrow.
4. Remove the two screws locking down the
right front lower cover followed by the cover.
Figure 1-3-48
Figure 1-3-49
Figure 1-3-50
Bypass table
Right cover
Developing duct cover
2-pin connector
Middle right cover
Right front lower cover
Pin
Pin
Right rear lower cover
Knock-out pieces
Right cover
Paper feed section lower cover
Knock-out piece
5. Break off the three knock-out pieces on the
right cover of the copier.
Note: Be sure to remove the burrs from the
cover using needle-nose pliers or a knife.
6. Remove the four screws locking down the
paper feed section lower cover followed by
the cover. Break off the knock-out piece on
the paper feed section lower cover.
Note: Be sure to remove the burrs from the
cover using needle-nose pliers or a knife.