Kyocera Mita KM-4530, Service Manual

Page: 277 / 384

2BC/D-1
1-6-73
(4) Adjusting the DF original center line
Perform the following adjustment if there is a regular error between the centers of the original and the copy image when
the DF is used.
Caution
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Figure 1-6-126
U034
(P. 1-6-17)
U067
(P. 1-6-36)
U072
Yes
No
Start
Enter maintenance mode.
Enter “072” using the numeric keys.
Press the start key.
Select the item to be adjusted.
Press the interrupt key.
Place an original on the DF
and make a test copy.
Is the image correct?
Press the start key.
The new setting
is stored.
Setting range (initial setting)
DATA (1 sided mode): –39 – +39 (–8)
DATA (front in 2 sided mode): –39 – +39 (–8)
DATA (rear in 2 sided mode): –39 – +39 (–7)
Changing the value by 1 moves
the center line by 0.17 mm.
For copy example 1, increase
the value using the cursor up key.
For copy example 2, decrease
the value using the cursor down key.
Press the stop/clear key to
exit maintenance mode.
End
DATA (1 sided mode): Center line in the 1 sided mode
DATA (front in 2 sided mode): Center line on the front
side in the 2 sided mode
DATA (rear in 2 sided mode): Center line on the rear
side in the 2 sided mode
Original Copy
example 1
Copy
example 2
Reference
1-6-69