Kyocera Mita KM-4530, Service Manual

Page: 224 / 384

2BC/D-1
1-6-20
(6-6) Adjusting the amount of slack in the paper at the vertical conveying
Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Figure 1-6-37
End
Start
Enter maintenance mode.
× ×
× ×
Enter “054” using the numeric keys.
Yes
Yes
No
No
Press the start key.
Select the item to be adjusted.
Press the interrupt key.
Press the start key
to make a test copy.
Decrease the value using the cursor down key.
Setting range (initial setting)
DUP LOOP ADJ : 0 – +200 (70)
DUP LOOP ADJ2 : 0 – +200 (70)
BYP LOOP ADJ : 0 – +200 (0)
Changing the value by 1 moves the amount of slack by 1.0 mm.
The greater the value,
the larger the amount of slack;
the smaller the value, the smaller
the amount of slack.
The new setting is stored.
Is the leading
edge of the image missing
or varying randomly (copy
example 1)?
Is the copy
paper Z-folded (copy
example 2)?
Increase the value using the cursor up key.
Press the start key.
Press the stop/clear key to
exit maintenance mode.
• Amount of slack in the paper of the vertical conveying
DUP LOOP ADJ : Duplex paper feeding (second face) of
A3, A5, 11" 17", and 5
1
/
2
" 8
1
/
2
" sizes
DUP LOOP ADJ2 : Duplex paper feeding (second face) of
B4, A4, B5, 8
1
/
2
" 14", and 11" 8
1
/
2
" sizes
BYP LOOP ADJ : Paper feeding through the bypass
Original Copy
example 1
Copy
example 2