KYMCO MXU 700i, Owner'S Manual

Page: 135 / 164

8.13. REAR BRAKE PADS
The clearance between the brake pads and brake
discs is adjusted automatically as the pads wear.
The only maintenance that is required is to replace
brake pads when they become worn. To check the
thickness of the brake pads use this procedure.
1. Remove a rear wheel.
2. Measure the thickness of each brake pad.
If the thickness of less than1.0mm (0.039in), take
your ATV to a KYMCO dealer to have brake pads
replaced.
3. Reinstall the wheel and tighten the lug nuts to
61N-m.
8.14. BRAKE FLUID INSPECTION
Check if the fluid level is below the lower level mark
through the inspection window.
(1) Lower level mark (sight glass)
NOTE:
1. Check the brake fluid level in brake fluid
reservoir. If the level in the reservoir is not visible
in the sight glass and below the lower lever mark,
add DOT 4 brake fluid.
2. If the sight glass appears dark, there is sufficient
amount of fluid reservoir.
3. Be careful not to spill any fluid when filling the
brake fluid reservoir. Wipe away spilled fluid
immediately.
127