Setting Latitude and Longitude
These screens are only seen if the GyroTrac ADCU is connected
to a TracVision G4.
When installing a satellite pair, it is also necessary to enter the
vessel’s latitude and longitude to ensure that the installed
satellites are viewable as well as to permit the system to set
several internal parameters.
54-0147
86
TracVision G4 Technical Manual
Proceed to "Selecting Active
Satellite"
Set Lat/Long?
Enter
Next
Return
Latitude:
##N
-
Enter
+
Longitude:
###E
-
Enter
+
Latitude:
##N
Longitude:
###E
Use the -/+ keys to select each
number and choose between NORTH
and SOUTH. Selecting ENTER will
cycle the display through each digit
and the direction option and then
launch the LONGITUDE screen.
Use the -/+ keys to select each number
and choose between EAST and WEST.
Selecting ENTER will cycle the display
through each digit and the direction
option and then display the selected
latitude and longitude.
This screen is displayed for
3 seconds before returning to
"Set Lat/Long?"
Figure 3-33
Set Latitude/Longitude Procedure
If the latitude and/or longitude
entered is not valid for the installed
satellite pair, the following screen
will appear:
Lat/Long not valid
for sat pair
Recheck and re-enter your latitude
and longitude and verify your
installed satellite pair to resolve this
issue.
Summary of Contents for KVHTRACVISION G4
Page 136: ......
