Setting the NMEA Outputs
GyroTrac is fully compatible with NMEA
input
versions 1.5
and 2.2. However, the individual serial ports can only be
programmed to use NMEA version 2.2 as an
output
.
Using the ADCU Interface
54-0147
71
Select output BWC?
Yes
Next
Cancel
Return to "Setting the Serial Outputs"
setting selection
Please Wait
Setup output GGA?
Yes
Next
Cancel
By choosing "Next" or completing the
configuration for each output, GyroTrac will cycle
through the remaining NMEA outputs in the
following order:
GGA – GLL – HDG – HDM – HDT – VTG – XTE
Each output follows the same sequence of
screens as illustrated in this flow chart.
Return to "Setting the Serial Outputs"
By choosing "Next" or completing the
configuration for each output, GyroTrac will
cycle through the remaining NMEA outputs.
Each output follows the same sequence of
screens as illustrated in this flow chart.
Figure 3-13
Setting NMEA Outputs
When Serial Ports 2 or 3 are
selected to provide NMEA output,
the baud rate is automatically
changed to 4800 baud from the
default of 9600 baud. Serial Port 1
and its pass-through duplicate only
provide 4800 baud output.
Custom configurations are not
available on GyroTrac.
Summary of Contents for KVHTRACVISION G4
Page 136: ......
