6. Place the foam seal in position on the mounting
surface with the hole centered over the cable
access cutout. Do not remove the paper backing at
this time. Scribe a line all around the seal.
7. Position the baseplate assembly in place over the
mounting holes and cable access, with the
baseplate’s “Forward” arrow (shown in Figure 2-4)
pointing toward the bow. Ensure that all holes line
up and that the connectors are centered over the
cable access as shown in Figure 2-5. Make any
necessary adjustments before seating the foam seal
in place permanently.
54-0161
16
TracVision G6 Technical Manual
Figure 2-4
Baseplate “Forward” Arrow
FWD
Figure 2-5
Baseplate/Foam Seal Orientation
(Bottom View)
